• Nr.3 (minimum, it would be better 4) complete PROTEUS-FAP and Nr.3 (minimum, it would be better 4) complete Standard PROTEUS with Remote Control Boxes, Remote Gas Power Boxes, Service Leads, Welding Cables (standard), Linking Cables for STTII (standard), Ceramic Cups, Welding Tips (for 1,2mm welding wires) and at least 1 PROTEUS-FAP HHPU.
  • At least nr.2 Guide Bands for each pipe diameter to be processed.
  • Nr.2 (minimum) Gas-Mixers and nr.2 Gas-Flow/Pressure-Regulators (heated) suitable for CO2 and Argon bottles.
  • Nr.3 Inverters Lincoln STTII
  • Nr.3 (minimum, it would be better 4 or even 5) Rectifiers or Inverters equipped with the pin for the remote start/stop.
  • Nr.1 Hydraulic Pipe-Beveling Machine for the pipe diameter to be processed
  • Nr.1 Internal Pneumatic or Hydraulic Line-up clamp for the pipe diameter to be processed
  • Nr.1 complete set of Cutting Tools and Tool-Holders for execution of the “J-type” bevel required by the PROTEUS-FAP fully automatic welding process
  • Nr.1 complete set of Cutting Tools and Tool-Holders for execution of the standard “30°” bevel
  • Nr.1 set (“induction-heating type” and/or “propane-type” if allowed) for the pre-heating of the pipe joints to be welded for each pipe diameter to be processed
  • Nr.2 (minimum) Welding Tents suitable for each pipe diameter to be processed, equipped with all the necessary lights-electric power-hooks-supports, etc…
  • Nr.4 (minimum) Grinders with discs for pipe-metal and slag removal brushes
  • Compressed Air for PROTEUS-FAP and joints cleaning
  • Nr.1 Flame-Cut unit suitable for the pipe diameter to be processed
  • Nr.1 pipe section (for each pipe diameter to be processed) 2,5-3 mt long with the agreed wall-thickness, for the housing of the clamp and the start of the serial of at least 5-7 joint-welds
  • Nr.7-8 pipe sections (for each pipe diameter to be processed) 1,5 mt long with the agreed wall-thickness, for the execution of the serial of 5-7 joint-welds (1-2 of them will be used for the preliminary test joints for parameters refining)
  • Welding masks, gloves, suits, safety shoes, helmets, etc…
  • Spanners, screw-drivers, Allen-keys, wrenches, hammers, rubber-hammers, chisels and any other possibly necessary tool.
  • Enough Basic welding electrodes suitable for the choosen pipe steel grade.
  • Enough Cellulosic welding electrodes suitable for the choosen pipe steel grade.
  • Enough 1,2mm Solid Welding Wire suitable for the choosen pipe steel grade.
  • Enough 1,2mm Flux-Cored Welding Wire suitable for the choosen pipe steel grade.
  • Enough 50lt bottles of pure CO2, Argon (Ar) and bottles of mix-gas 80% Argon – 20% CO2 (or 75%-25% might be anyway acceptable)
  • Nr.2 Volts/AmSIAP meters suitable to measure AmSIAP and Volts of the welding process
  • Nr.1 Lifting Machine suitable to lift the pipe sections, the jointed pipe sections, the clamp, the pipe-facing machine, the welding tents, etc…